Western-digital My Book Pro Edition II User Manual Manual de usuario descargar pdf (Pagina 13)

MY BOOK PRO EDITION II

USER MANUAL

MY BOOK RAID MANAGER FOR MAC – 10

Condition Messages

My Book RAID Manager reports the following condition messages depending on the

current status of your drive.

Message Description

Healthy Your device is “healthy” and operating.

Degraded Your device is still functioning but the drive in either slot A

or B may have a problem. Refer to section 7 of this manual

for information on how to replace a drive.

Rebuilding Your device is in RAID 1 mode and is rebuilding the data

for a newly replaced disk. The rebuilding process may take

up to 12 hours depending on the capacity of your drive.

Your data in the device is still accessible while it's

rebuilding.

Bad Your device may have a problem. Disconnect then re-

connect the power cable and/or the interface cable. If the

problem persists, visit our WD knowledge base at

support.wdc.com for more information and help.

Setting Mismatched Your device is in RAID 1 mode with both drives detected as

master. You must designate a single master (disk A or B)

using RAID Manager. The data on the master will be

accessed and mirrored to the secondary drive during the

rebuilding process.

Not Configured The RAID setting is not configured. Use RAID Manager to

configure it to either RAID 0 or RAID 1.

Unknown The RAID configuration information is not available. The

driver for My Book interface device may not be installed

properly. Turn off the device, re-install My Book RAID

Manager and/or drivers from the software CD and turn the

device back on. Your system should detect My Book and

prompt you to install the driver. Allow your system to

automatically locate the driver and complete the installation.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 28 29

Sin comentarios

Western-digital My Book Pro Edition II User Manual Manual de usuario Pagina 13