Western-digital My Cloud EX2 User Manual Manual de usuario descargar pdf (Pagina 17)

GETTING STARTED

WD MY CLOUD EX2 PERSONAL CLOUD STORAGE

USER MANUAL

4. Plug the other end of the power adapter into a power outlet. The unit powers up

automatically.

Important: Wait for the WD My Cloud EX2 device to finish powering up

(approximately three minutes) before configuring it. You will know it

is ready when the power LED stops flashing and turns blue.

5. When the power LED on your device turns a solid blue, continue to “Getting

Started Using Online Setup Software” on page 13.

LEDs

Front Panel Power LED

The following table describes the front panel power LED behavior.

State Color Appearance State Description

Power Down Black (off) ------- Drive in standby/sleep mode.

Powering Up Blue Flashing Device is powering on or in the process of

updating the firmware.

Power Up Blue Solid Device is in a power up (on) state.

Power Up (degraded) Red Flashing Device is powered up but the volume is

degraded.

Action required Yellow Flashing A condition, such as a network cable has

become unplugged, which requires you to

act.

Note: For non-compatible drives, the power LED blinks yellow during power up.

Front Panel Hard Drive (HDD) LEDs

The following table describes the front panel hard drive LED behavior.

Function Color Appearance Function Description

No drive Black (off) ------ Drive is not present.

Drive present, no

activity

Blue Solid Drive is present but there is no activity.

Active drive Blue Flashing Drive is present and showing drive activity.

Hard drive fault Red Flashing Drive is present but has a hard drive fault or

failure.

Note: For incompatible drives, the hard drive LEDs blink red rapidly as the unit

powers up.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 167 168

Sin comentarios

Western-digital My Cloud EX2 User Manual Manual de usuario Pagina 17